A cable built to your measurements.

Give us the length from lug hole to lug hole and tell us how the ends should look. We cut it, crimp it, seal it, label it and ship it.

1 The cable

SizeNot sure? Use the wire calculator.

Color

How many

2 Length, hole to hole

Measure from the centre of one lug hole to the centre of the other, with the cable lying the way it will sit in the van. Not the bare copper, not the bolt faces.

Feet

Inches

Tolerance± 1/4 inAllow a little slack; a cable pulled tight stresses the terminal.

3 The ends

End A

Lug hole Lug angle

End B

Lug hole Lug angle

How the two lugs face each other Lay the cable as it will sit and look along it from one end. This is the twist between the two lug faces.

Lug material Tinned copper for anything damp or salty. Aluminum only where the terminal is aluminum too.

4 Finish

Adhesive heat shrink on both endsSeals the lug barrel against water. What we put in the kits. Full sleeve over the whole cableBraided sleeve end to end, plus shrink on both ends. For runs that rub or show. Bare, no shrinkYou seal it yourself.

Label both ends with what they connect to (free; tell us the two names in the notes)

Notes for us

5 Check it twice

Made to order, non-refundable. This cable is cut and crimped to the numbers above. We cannot take it back or re-use it, so please measure again before you send it. If you are unsure, ask us first and we will check it with you for free.

I measured hole to hole, I have checked it twice, and I understand this cable is made for me and cannot be returned.

Estimated total$0